How to deal with the damaged wooden door?

How to deal with the damaged wooden door? Here are 9 ways to deal with damage to wooden doors

1, scratch treatment, if the wooden door accidentally scratched, but did not touch the wood below the paint film, can use a soft cloth dip a little melted wax, paint on the film wound, cover the scars, when the wax hardens, and then coated with a layer, so repeatedly painted a few times, you can cover up the scars.

2. Remove ink stains by adding two parts white vinegar to one part of water. Sponge the mixture over the ink stains on the wooden door, then wash and dry them.

3. Remove Water Marks, which usually take a while to disappear. If it is still visible after a period of time, rub a clean soft cloth with a little salad oil or mayonnaise along the grain of the water mark, or cover the mark with a damp cloth, then carefully press the wet cloth with an electric iron several times, the print can be diluted.

4, remove oil stains, residual tea is an excellent detergent, after smearing and then spray a small amount of corn powder to try, finally the corn powder can be smeared clean, corn powder can absorb all the dirt adsorbed on the surface of the wooden door, make the paint smooth and bright.

5, white or light-colored wooden door yellow, white or light-colored paint on the surface of the wooden door, over time will become yellow, such a situation can be tried with a cloth dip toothpaste.

6. To protect your hardware, simply wipe with a dry cloth, and don't use chemical cleansers. 7, remove the sticky paper, the paper with salad oil completely soaked, after a few minutes with wood door special steel wool according to the direction of wood grain gently wipe, dry after glazing can be.

8. Soften the burn marks. If a cigarette end or an unextinguished source of fire leaves a burn mark on the wood door paint, if the Paint Burns, cover the matchstick or toothpick with a fine-grained cloth, gently rub the burn mark, and then apply a thin layer of wax, the scorch mark will fade away.

9, the removal of foam, solid wood door surface with excess foam is common in the installation process of solid wood, once the foam accidentally get on the surface of the wooden door, remember not to rush to wipe off the foam. Should ignore it, when the foam completely cured, with a wrench down on the line, will not leave an obvious imprint, otherwise, the more rub more and more, sticky everywhere, make a mess. The beauty of wooden door needs to be cared for, whether it is the usual unintentional knock, or as time goes by, wooden door gradually luster no longer, need more care, in order to make wooden door eternal youth. In life, may wish to pay more attention to the state of wooden doors, timely take appropriate measures, care and maintenance of wooden doors, will be able to let the wooden doors still shiny, [Life extension.".